Specification - Axminster D.R.O. Micro Drill User Manual

Initial Assembly Instructions Continued...
W
A X M I N S T E R
W H I T E
Assemble the Depth (4) collar and ring (3) onto the column firmly.
(Fig 2)
Insert the Star Knob (2) complete with the two clamp bushes (21, 22) into the headstock
location.
Make sure the two cut outs are lined up towards the rear so as to allow the column to slide
past them.
Slide the headstock onto the column (6), you can see down the hole to make sure the
clamp cut outs mentioned above are clear of the column. When the column is completely
through the headstock casting you can tighten the Star Knob to clamp the headstock into
position.
Clean the spindle of any grease or oil and push the drill chuck (10) onto the spindle firmly.
Turn the chuck to make sure it is tight.
Put the handle (5) into the handle socket (7) and tighten with the wrench provided.
(Fig 1)

Specification

Axminster No.
Max Drilling Capacity.
Spindle Travel
Headstock Travel
Spindle Taper
Speed Range
Base size
Column size
Motor power
Weight
08
www.axminster.co.uk
200021
6mm (1/4")
40mm (1.1/2")
200mm (8")
B10
Low range 0-3600 rpm
High range 0-5000 rpm
275mm X 165mm
30mm X 390mm
150 W DC
14 KG