Avery Dennison ALS 204 User Manual page 57

6 O
PERATIONAL FAILURES
6.1 S
TATUS MESSAGES
Status Status text
5140 Rewinder control
5143 Rewinder Stop
5145 Rewinder full
[62] List of error messages
Cause
Rewinder control
During problem-free operation,
the rewind unit dancer arm only
moves a minimal distance
around the "control position".
This is the position the dancer
arm takes up after initialisation
of the machine.
– Any force applied that moves the
dancer arm from its control position.
Example: The feed motor is blocked;
the backing paper is not conveyed
quickly enough; as a result the
dancer arm is pulled upwards.
Example: The backing paper is torn;
the dancer arm springs downwards.
– This message appears when the
dancer arm was held against its
upper stop for more than two
seconds.
Effect:
Power to the rewinder motor is
switched off, so that the rewinder can
be turned easily by hand.
This effect is helpful when
installing a new label roll,
because the rewinder can be
turned easily.
This error can only occur if the
end of a new label roll was glued
on to backing paper that had
already been wound onto the
rewinder.
– The maximum permitted diameter
(205 mm) for the rewinder roll has
been reached.
57
Action to take
Press the key.
– This reinitialises the dancer arm
control; the dancer arm moves back
into the control position.
Press the key to confirm the
error message.
Remove the rewound backing paper
Press the key to confirm the
error message.
ALS
20x
256
GB