Troubleshooting; Removing Supplies; Maintenance/Lubrication - Avery Dennison Monarch 1115 Operating Instructions

OPERATION
Squeeze and release operating lever.
1
Pull labeler to apply label.
3
(Gentle wiping motion.)

REMOVING SUPPLIES

Tear label strip at label roll as
1
shown and pull label roll from
between hubs.
Tear
MAINTENANCE
With label roll removed, check
1
label track and backing paper
track for stray labels.
Front
Exit
LUBRICATION
If adhesive buildup occurs, lubricate as shown
with labels loaded.
Monarch lubricant is recommended.
Lubricate:
One drop each side of label
chute between spring and
backing paper.
Lubricate:
One drop each spot on
backing paper (total of
four drops). Spread
with finger.
DO NOT OVER
LUBRICATE!

TROUBLESHOOTING

Trouble
Characters not printing.
Bands not inked.
Labels feed slowly or
hesitantly.
Labels will not feed.
Print incorrectly located.
Printing smeared or
distorted.
Printing too light.
Black
Rollers
Tear backing paper strip.
2
Pull label strip from labeler.
Clear label track by squeezing
2
operating lever and feeding label
removal strip under brake wheels and out
front of labeler.
Brake
Wheels
Removal
Strip
OPERATION, REMOVING SUPPLIES & MAINTENANCE
Remedy
Check ink roll per Inking
instructions.
Follow Lubrication and
Maintenance Instructions.
Reload per instructions. Use
correct supplies.
Follow Maintenance instructions.
Follow Print Adjustment
instructions.
Print several labels (15 to 25) to
use up excess ink.
Squeeze operating lever harder
during operation.
Visit www.paxar.com for sales, service, supplies, information, and telephone
numbers of our locations throughout the world.
TOLL FREE:
1-800-543-6650 (In the U.S.A.)
1-800-263-4650 (In Canada)
LUBRICATION, PRINT LOCATION, & TROUBLESHOOTING
2
3
to be pulled out.
Pull Strip
3
Print location is correct when extreme
1
right-hand and left-hand characters are located
as shown.
Approx. 1/16 inch (1.6 mm)
Place small coin in feedwheel button slot.
2
Feedwheel
Button Slot
Push feedwheel button IN COMPLETELY
3
and turn slightly clockwise if print is too far left or
slightly counterclockwise if print is too far right.
Adjustment made without completely depressing button
are temporary.
4 Repeat steps 2 and 3 until print is correctly
located.
Product warranty statements may vary from country to
country. Please contact the authorized PAXAR/Monarch
representative in your country for details.
Place black rollers on item to
be labeled.
DO NOT POUND labeler when
applying labels.
Squeeze and release operating
lever until backing paper is free
Tear Backing
Paper
To clear backing paper track:
a. Insert label removal strip in end of
track to loosen stray labels.
b. Insert label removal strip as
shown, using corner to remove stray
labels.
End of
Track
PRINT ADJUSTMENT
Approx. 1/16 inch (1.6 mm)
Warranties