Avery Dennison ALS 330 User Manual page 48

Operators Manual
ALS 330/430
End of air stream signal ___________________________________________ ASTP
This parameter determines how long the air stream signal will remain active after the label
dispense has finished. Valid in all modes (direct dispense, applicator, APSF and fixed-speed).
Printer dwell time__________________________________________________ PDT
This determines the dwell time of the stamp-printer. A new dispense is prevented after PDT
expires for a time equal to 50% of PDT.
Save parameter in data bank _______________________________________SAVE
Function: After selection this function you can save the current parameter setting to a data
bank.
Always available.
Range: NEW1 .. NE15
PD01 ... PD15 Overwrite existing data bank
EXIT
Load data bank _________________________________________________ LOAD
Function: After selection this function you may load a predefined parameter setting.
Always available.
Range: PD01 ... PD15
EXIT
Leave Menu finishing _____________________________________________ QUIT
Function: If this function is selected, you get back to the standard menu
Always available.
Note: Modified parameter values are only stored if the menu is left by using the
QUIT function. If the power is switched off before leaving the menu by quit all
modifications are lost.
Release 8/07
Create a new data bank
Leave function without modification
Load a defined data bank
Leave function without modification
Page 46 Menu structure