Bit Definition In Error Flag; Bit Definition In Warning Flag - Avery Dennison ALS 230 User Manual

Operators Manual
ALS 230
#!LABC The machine sends the number of dispensed labels e.g. LABC0000008359 back
#!SP__ The machine is set to off. The product sensor is disabled and labelling will
therefore be stopped.
#!SR__ The machine is set to on. The product sensor is enabled and labelling can
restart.
For a full automatic operation, the following procedure in case of an error is required:
#!XC Pharmacy Code ackn.
Pharmacy Code acknowledgement
#!XC delivers the data of the last printed pharmacy bar code. Delivery occurs in
the form:
xxxxxxxyyyyyyyy (Code content without checksum), with:
xxxxxxx = 7-digit CNK number
yyyyyyyy = 8-digit sequential number
If no pharmacy bar code was printed since the last printer reset, the delivery is
000000000000000.
•
#!ERRF
•
#!CLRE
•
#!SR__
7.2.1

Bit definition in error flag

Error number Error message in display
0 E__0
1 E__1
2 E__2
3 E__3
4 E__4
5 E__5
6 E__6
7 E__7
8 E__8
7.2.2

Bit definition in warning flag

Warning Message in display
0 W__0
1 W__1
2 W__2
3 W__3
4 W__4
5 W__5
6 W__6
7 W__7
Release 12/07
Request error
Clear error message after fixing the error. The labeller shows „INIT"
Clear INIT message
Error description
Pressure roller open
End of material (4 missing labels)
EP-applicator error
checksum error configuration data
checksum error parameter bank
Error 10V low
Error 24V low
missing label on product
Error motor driver
Warning description
Next product start before finished
Product start but no material not initialised
EEPROM error during write
Interface warning
APSF speed too fast
End of material (OD-Control)
too many products
Loop not ready (720)
Page 56 Serial interface