Avery Dennison ALS 230 User Manual page 76

Operators Manual
ALS 230
Message Meaning
E__5 10V supply voltage for label
sensor low.
E__6 24V Voltage low
E__7 Material initialization failed
E__8 Error stepper motor driver
E__9 10V supply for label sensor too
high
E__10 Missing label on product
___0 Process error (Divide overflow)
___1 Illegal interrupt (processing error)
___2 Illegal bank interrupt (processing
error)
INTO Illegal interrupt INTP0 (processing
error)
Release 12/07
How to solve
Short circuit in label sensor or cable.
Voltage regulator U14 is damaged.
Short circuit on an output. Total load too
high i.e. max is 3A for all outputs.
Voltage regulator U1 is damaged.
Change main board.
Check if the label web is threaded
through the label sensor
The stepper motor control has detected
an error. The fault is indicated by the
LED's on the driver.
Voltage regulator U14 damaged
One or several product could not be
labelled. Distance between products too
close. Increase speed of printer.
Hardware failure external noise. EPROM
damaged. Turn off power and on again.
Change EPROM or main board
Hardware failure external noise. EPROM
damaged. Turn off power and on again.
Change EPROM or main board
Hardware failure external noise. EPROM
damaged. Turn off power and on again.
Change EPROM or main board
Hardware failure external noise. EPROM
damaged. Turn off power and on again.
Change EPROM or main board.
Page 74 Errors and warnings