Table of Contents
Advertisement
6
O
PERATIONAL FAILURES
6.1 S
TATUS MESSAGES
Status Status text
5147
Tandemsynch. Init
5152
Winding direct.
5200
Home position
5201
Touch Down
6002
New prog. vers.
6030
New Parameters
6207
No file card
[67] List of error messages
Cause
This message can only appear
during tandem operation.
– Communication between the master
and slave machines is not
functioning.
The backing paper end is not correctly
attached to the rewinder mandrel.
This message may appear when
operating the applicator. The
applicator did not reach its home
position (upper end position)
within the intended time-frame.
– Applicator operation set, but no
applicator available.
– The applicator is stuck.
– Compressed air applicator:
Compressed air supply interrupted or
switched off.
– Cable not correctly connected.
The applicator lower end position
(Touch Down) was not reached in time.
New firmware has been loaded. This is a
message from the labeller that new
firmware is available.
New firmware was loaded with the result
that new functions have been added to
the menu.
No compact flash card was found.
59
Action to take
Check, if the slave machine had
been switched on before the master
machine - if not, repeat the switching
on in the correct order (first slave,
then master).
Check, if both machines are
connected with the tandem interface
cable - if not, connect them. For
detailed information, contact a
service technician.
Attach the backing paper web to the
rewinding mandrel as described in
chap. "Threading the label web to the
rewinder" auf Seite 42.
SIGNAL INTERFACE > Interface mode
Set
to „PLC interface".
Remove any obstructions
Check compressed air connection
and reconnect correctly if necessary.
Check cable and connect correctly if
necessary.
Press the Online button to confirm.
– All parameters are reset to their
factory settings.
Press the Online button to confirm.
– Automatic reset is performed.
– All parameters are reset to their
factory settings.
Check whether a compact flash card
is connected. If the compact flash
card was not connected until after the
machine was switched on: Switch the
machine off and back on again.
ALS
306
309
GB
Advertisement
Table of Contents
