Using The Overscan Function - Avermedia AVerTV 6.3 User Manual

2. Clear the Enable check box so that you will not access that channel
when you press Channel Up/Down buttons.
3. However, you can still see the channel in your program list. If you want to watch that
channel again some day just select the Enable check box.
4.10

Using the OverScan Function

On some broadcast channels, you might see
distorted lines or black spaces on the top, sides,
or bottom of the screen. These video artifacts
derive from the source signal, and can be masked
using the OverScan feature.
To hide the edges of the picture:
Right-click on the TV Monitor and choose
OverScan to enable it.
OR,
1. Right click on the TV monitor. When a pop-up menu appears, select Individual
Channel Setting. Or click Program List button
click Individual Channel Setting button
2. When a dialog box appears, select Video tab.
3. Use and
4. To have equal margins of all sides, click on the Lock All icon
increase or decrease the number (0~50) as you prefer.
5. For equal left and right margins, select the Keep Vertical Ratio check box. For equal
top and bottom margins, select the Keep Horizontal Ratio check box. Then use
adjust the margin height or width.
6. If you just want to apply OverScan setting to one specific channel, select Configure
the settings only for single channel and repeat step 3 to 5.
7. To apply the converted settings to all channels, click Apply All button
8. Click Default button
(This picture is only for reference.)
to adjust either side of the margins for a better quality image.
if you want to revert the factory settings.
.
55
on the control panel and then
. Then use
.
to
to