Table of Contents
Advertisement
Safety Instructions
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has
A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong is provided for your safety. If the
provided plug does not fit into your outlet, consult and electrician for replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from
the apparatus.
11. Only use attachments/accessories specified by the manufacturer.
12. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as
power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to
rain or moisture, does not operate normally, or has been dropped.
13. WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.
14. Lightning - For added protection for this product during a lightning storm, or when it is left unattended and unused for long periods of time,
unplug the host system (Ex. computer) from the wall power outlet, and disconnect the antenna or cable system. This will prevent damage to
the product due to lightning and power-line surges.
15. Power Lines - An outside antenna system should not be located in the vicinity of overhead power lines or other light or power circuits, or
where it can fall into such power lines or circuits.
16. Antenna Installation - When installing an outside antenna system, extreme care should be taken to keep it from touching such power lines or
circuits, as contact with them may be fatal.
17. Outdoor Antenna Grounding - If an outside antenna is connected to the product, be sure that the antenna system is grounded so as to
provide some protection against voltage surges and built up static charges. Article 810.21 of the National Electric Code, ANSI/NFPA No.70,
provides information with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to the antenna
discharge unit, size of grounding conductors, location of antenna-discharge unit, connection of grounding electrodes, and requirements for
the grounding electrode.
18. NOTE to CATV System Installer-This reminder is provided to call the CATV systems installer's attention to Section 820.93 of the National
Electric Code, ANSI/NFPA 70:2005 (for US/Canada) and/or EN60728-11:2005 standard (for Europe), which provide guidelines for proper
grounding and, in particular, specify that the Coaxial cable shield shall be connected to the grounding system of the building, as close to the
point of cable entry as practical.
Battery Safety Information:
Store the batteries in a cool dry place.
Do not dispose of used batteries in domestic waste. Dispose of batteries at special collection points or return to point of sale if applies.
Remove the batteries during long periods of non-use. Always remove exhausted batteries from the remote control. Battery leakage and
corrosion can damage this remote control, dispose of batteries safely.
Do not mix old and new batteries.
Do not mix different types of batteries: alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).
Do not dispose of batteries in a fire. The batteries may explode or leak.
Never short circuit the battery terminals.
two blades with one wider that the other.
Advertisement
Table of Contents
