One-Piece.deep.wall.sleeve.installation.(Pdxwsext) - Friedrich 920-087-09 (12/10) Installation And Operation Manual

5. Drill.two.3/16".holes.through.each.side.of.the.sleeve.approximately.
4".from.top.and.4".from.bottom.of.sleeve...Screw.four.#10.x.1".
screws. (included). or. appropriate. fasteners. for. your. installation,.
through.the.holes.in.the.sides.of.the.wall.sleeve.
6. Apply.sealant.around.the.wall.sleeve.where.it.projects.through.the.
inside.and.outside.wall.surfaces...Apply.the.sealant.to.the.screw.
heads.or.the.tops.of.the.fasteners.used.in.Step.#5.
Figure 10
Lintel Installation
JACK STUDS
MAIN STUDS
NOTE: Construct wall opening to comply with all applicable building codes.
One-Piece Deep Wall Sleeve
Installation (PDXWSEXT)
If.the.wall.is.thicker.than.13.1/4".a.deep.wall.sleeve.or.wall.sleeve.extension.
MUST.be.used...The.deep.wall.sleeve.may.be.special.ordered.through.
your.Sales.Representative.
7. If.the.chassis.and.exterior.grille.are.to.be.installed.later,.leave.the.
weatherboard.and.center.support.in.place,.otherwise.remove.and.
dispose.of.them...(See.Figure.13,.Page.12).
8. Provide.a.support.lintel.if.the.wall.sleeve.is.installed.in.a.concrete.
or.masonry.wall.(See.Figure.10,.Page.9).
MAIN STUDS
JACK STUDS
NO HOLES IN BOTTOM OF WALL
SLEEVE UNLESS DRAIN KIT IS USED
LINTEL
MOUNTING
SCREW HOLES
FRP010
9