Show Port Blocking - Avaya P334T User Manual

show port blocking

Use the show port blocking command to display the port blocking mode on a
particular switch. Use the session command to change switches before using this
command.
The show port blocking command is used with the
show self-loop discovery command to confirm a port's blocking mode.
The syntax for this command is:
show port blocking
Note: This command is not supported by the P330-ML switches.
Note: If this command is to be implemented on a switch other than the stack master,
a session should be opened to the relevant switch.
Avaya P334T User's Guide
Chapter 6 CLI – Layer 2
55