Table of Contents
Advertisement
Output Example:
P330-N# set arp-tx-interval 15
ARP tx interval was set to 15 seconds.
set self-loop-discovery Admin_Status
Use the set self-loop-discovery Admin_Status command to enable or
disable IBM token ring discovery feature at the module level.
Note: You must disable Spanning Tree before you can enable self-loop-discovery.
Note: This command is not supported by the P332G-ML and P332GT-ML switches.
The syntax for this command is:
set self-loop-discovery Admin_Status <enable|disable>
<modul num>
Example:
P330-N# set self-loop-discovery Admin_Status enable 1
Self-Loop-Discovery is disabled on module 1.
set welcome message
Use the set welcome message command to set a welcome message to appear
after a reboot or after opening a new session (see session command) in the stack.
The syntax for this command is:
set welcome message [string]
string
Output Example:
P330-N# set welcome message avaya
The new welcome string is "avaya"
Avaya P334T User's Guide
string - The string to be used as the welcome message.
blank - Restores the default string.
Chapter 6
CLI – Layer 2
121
Advertisement
Table of Contents
