Connecting With Keyboard Wedge - Honeywell VOYAGER 1250G User Manual

2. The scanner beeps.
3. Verify the scanner operation by scanning a bar code from the
Symbols
The unit defaults to a USB PC Keyboard. Refer to
terminal settings.
For additional USB programming and technical information, refer to "USB
Application Note," available at

Connecting with Keyboard Wedge

A scanner can be connected between the keyboard and PC as a "keyboard
wedge," plugged into the serial port, or connected to a portable data termi-
nal in wand emulation or non decoded output mode. The following is an
example of a keyboard wedge connection:
1. Turn off power and disconnect the keyboard cable from the back of the
terminal/computer.
2. Connect the appropriate interface cable to the scanner and to the
terminal/computer.
3. Turn the terminal/computer power back on. The scanner beeps.
4. Verify the scanner operation by scanning a bar code from the
Symbols
The unit defaults to an IBM PC AT and compatibles keyboard wedge inter-
face with a USA keyboard. A carriage return (CR) suffix is added to bar
code data.
1 - 2
in the back of this manual.
www.honeywellaidc.com.
only if
power
supply is
included
in the back of this manual. The scanner beeps once.
Sample
page 2-5 for other USB
Sample