Character Deactivation Mode; Deactivation Character - Honeywell VOYAGER 1250G User Manual

Character Deactivation Mode

If you have sent a character from the host to trigger the scanner to begin scan-
ning, you can also send a deactivation character to stop scanning. Scan the On
bar code below to use character deactivation, then use Deactivation Character
(following) to select the character you will send from the host to terminate scan-
ning. Default = Off.
* Off

Deactivation Character

This sets the character used to terminate scanning when using Character
Deactivation Mode. On the
1252), page A-4, find the hex value that represents the character you want
to use to terminate scanning. Scan the bar code below, then use the
Programming Chart
that ASCII character. Scan
ASCII Conversion Chart (Code Page
to read the alphanumeric combination that represents
Save to finish.
Deactivation Character
On
3 - 15