Function Code Transmit; Communication Check Character - Honeywell VOYAGER 1250G User Manual

Function Code Transmit

When this selection is enabled and function codes are contained within the
scanned data, the scanner transmits the function code to the terminal. Charts
of these function codes are provided in
page 7-2. When the scanner is in keyboard wedge mode, the scan code is con-
verted to a key code before it is transmitted. Default = Enable.
* Enable

Communication Check Character

To enhance security, you can specify the transmission type of a check charac-
ter; either LRC where the calculation starts on the first transmitted character,
LRC where the calculation starts on the second transmitted character, or CRC.
Note: This option adds a check character to the bar code data for all
symbologies. If you need to enable or disable check characters for
individual symbologies, see
Scan the bar code below to set the communication check character type.
Default = None.
* None
LRC Starts on 2nd Character
4 - 6
Supported Interface Keys
Symbologies beginning on page 6-1.
LRC Starts on 1st Character
starting on
Disable
CRC