Beeper Duration - Good Read; Number Of Beeps - Good Read; Number Of Beeps - Error - Honeywell VOYAGER 1250G User Manual

Beeper Duration – Good Read
The beeper duration codes modify the length of the beep the scanner emits
on a good read. Default = Normal.
* Normal Beep
Number of Beeps – Good Read
The number of beeps of a good read can be programmed from 1 - 9. The
same number of beeps will be applied to the beeper and LED in response
to a good read. For example, if you program this option to have five beeps,
there will be five beeps and five LED flashes in response to a good read.
The beeps and LED flashes are in sync with one another.
Note: The LEDs can also be programmed separately. See
Settings
To change the number of beeps, scan the bar code below and then scan a
digit (1-9) bar code and the
inside the back cover of this manual. Default = 1.
Number of Beeps – Error
The number of beeps and LED flashes emitted by the scanner for a bad
read or error can be programmed from 1 - 9. For example, if you program
this option to have five error beeps, there will be five error beeps and five
LED flashes in response to an error.
Note: The LEDs can also be programmed separately. See
Settings
3 - 4
on page 3-6.
Save
Number of Good Read Beeps/LED Flashes
on page 3-6.
bar code on the Programming Chart
Short Beep Short Beep
LED
LED