Honeywell VOYAGER 1250G User Manual page 101

Select Require to prevent the scanner from decoding a single "D" Codabar
symbol without its companion. This selection has no effect on Codabar
symbols without Stop/Start D characters.
On
Require
Concatenation Timeout
When searching for bar codes during concatenation, you may wish to
set a delay used to find the next bar code. Set the length (in millisec-
onds) for this delay by scanning the bar code below, then setting the
timeout (from 1-65535 milliseconds) by scanning digits from the
Programming
Codabar Redundancy
If you are encountering errors when reading Codabar bar codes, you may
want to adjust the redundancy count. Redundancy adjusts the number of
times a bar code is decoded before transmission, which may reduce the
number of errors. Note that the higher the redundancy count, the longer it
will take to decode the bar code. To adjust the redundancy, scan the Cod-
abar Redundancy bar code below, then scan a redundancy count
between 0 and 10 on the
manual. Then scan the
Chart, then scanning Save. Default = 750.
Concatenation Timeout
Programming Chart
bar code. Default = 0.
Save
Codabar Redundancy
* Off
inside the back cover of this
6 - 5