Table of Contents
Advertisement
No packet loss will occur.
5.5 Auto-Negotiation
The STP ports on the Switch have built-in "Auto-negotiation". This technology automatically sets the best possible bandwidth
when a connection is established with another network device (usually at Power On or Reset). This is done by detect the
modes and speeds at the second of both device is connected and capable of, both 10Base-T and 100Base-TX devices can
connect with the port in either Half- or Full-Duplex mode.
If attached device is:
10Mbps, no auto-negotiation
10Mbps, with auto-negotiation
100Mbps, no auto-negotiation
100Mbps, with auto-negotiation
100Base-TX port will set to:
10Mbps.
10/20Mbps (10Base-T/Full-Duplex)
100Mbps
100/200Mbps (100Base-TX/Full-Duplex)
Advertisement
Table of Contents
