Dma-100W Configuration; Options Screen - Planet DMA-100W User Manual

Wireless Digital Media Adapter User Guide
Chapter 4

DMA-100W Configuration

This chapter describes how to use the configuration and maintenance features of your
100W.
Note: We suggest you to re-login to DMA-100W Server after changing any settings of DMA-
100W.
The DMA-100W uses an on-screen menu interface. As you move through the menus, you will
use the selection arrows on the remote control to move up, down, right and left. Or you can use
Tab button to move. The highlight bar moves from item to item as you press the selection
arrows. In some instances you will need to press ENTER on the remote control to access the
pull down menu within an item. You will then see an arrow within the highlighted bar. These
arrow "hints" help you with menu navigation, and show you the possible paths you may take. For
example, a down arrow hints that more items are available if you move the highlight bar down.
After all hardware connection has been done and the DMA-100W Server software is installed
and configured, you can power on DMA-100W. Wait for 30 seconds, the Login page will show
up on your TV screen. If there's no screen showed up, make sure all the connections are correct
and press the "TV Mode" button on the remote control to switch the Video output mode. The
default video output mode is NTSC. Press the TV Mode until the screen show up.
Note: For the first time using DMA-100W, do not directly log into Media Server. Please go to
setup page to configure DMA-100W first. To access the setup page, click the "Setup" button on
remote controller. A tool tray will arise as the picture below. Please use the Left/Right arrow key
to select the most right option and click "Enter" to access "Setup" page.

Options Screen

Screen Saver You can specify the time duration before screen saver displays.
4
DMA-
Click to enter
"Setup" page
24