Table of Contents
Advertisement
2
Chapter 2
Installation
Hardware Connection
This chapter describes the different topologies of the DMA-100W and how to connect the
topology with your DMA-100W and TV.
Under every situation the DMA-100W must be wired to the TV or other display device. The
following image shows the simple connection of the DMA-100W and the related equipments.
All audio, video, and networking connections are located on the rear panel of the DMA-100W.
Before starting to connect cables to your TV, Stereo system and network, determine which type
of cable your television, Stereo system uses and your network type (wired or wireless).
Connect Video
Note: The TV Mode button on the remote control toggles between the composite, S-Video
output, component output and DVI output. After hardware connection, switch it to the correct
video output via press the button.
Composite Video:
Connect the supplied yellow video cable to the Composite Video port on the back of the DMA-
100W. And the matching opposite end of the cable to your television input.
V ide o Out pu t
Audio Out put
RCA
S /P DIF
Y
P b
P r
Re se t
DC In
DV I
S -Vide o
Co mp .
L
R
Opt ic a l Coa x.
LAN
S-Video:
7
Advertisement
Table of Contents
