Panasonic AG-RCP30P Operating Instructions Manual page 56

Error messages
No.
E20801 The recorder reboots by
unrecoverable card ejection
error.
E20802 The recorder reboots by
unrecoverable card insertion
error.
E20803 Card is not ready.
Please try to reinsert the card,
or Reboot from Menu.
E22420 Officer's information file
cannot be loaded.
E22421 Since you are not an
administrator, you cannot
open this menu.
E22422 Officer's information file
cannot be loaded.
E22423 Admin's information file
cannot be loaded.
E22424 Officer's information cannot
be setup during record !
E22620 Couldn't start auto maintenance Auto maintenance was not performed
E25410 GPS communication error.
Please check the GPS module.
E28201 A capacity of USB strage is
not enough to export.
E28202 Export completed
Restore file remained.
E28203 File not found in P2 cards.
E28400 No USB storage devices.
Couldn't start export.
E28401 Found read only P2 cards.
Couldn't start export.
E28402 All USB storages are read only.
Couldn't start export.
56
(continued)
Message Measure
Be sure to use the correct procedure to
remove and load P2 cards.
Check the P2 card and re-insert it, or
reboot the Memory Card Video Recorder.
The officer data file (wid
corrupted. Create a new officer's data
file, save it to a USB memory device
and re-register it.
You are not registered as an
administrator and cannot open this
menu. Ask a registered administrator for
assistance.
There is no Officer Registration file
or it contains the wrong data. Create
a correct Officer Registration file
(wofficer.txt), copy it to a USB memory
device and reload it.
There is no Administrator Registration
file or it contains the wrong data. Create
a correct Administrator Registration file
(wadmin.txt), copy it to a USB memory
device and reload it.
Officer data cannot be changed during
recording. Stop recording and start over.
because the P2 card slot cover was open
or because recording was in progress.
An error occurred in the GPS function.
Consult your supplier.
Use other USB memory device that is
not full.
Restore the file not yet restored, and
export it again.
There are no files to export. No export
operation needed.
Connect a USB memory device.
Set the P2 card write-protect switch
away from the write-protect position.
Connect a write-enabled USB memory
device.
∗∗∗∗∗
.txt) is