Installing Your Machine; User Parameters; Setting The User (Internet) Parameters - Panasonic DP-2000 Operating Instructions Manual

Installing Your Machine

User Parameters

Setting the User (Internet) Parameters

See Operating Instructions (For Facsimile) if you wish to set the basic settings (User Parameters).
Before starting, you will need a completed copy of page 15 (Pre Installation Information). For your machine to
be able to operate on the Network properly, the following five (5) Basic Parameters must be pre-programmed
into the machine.
• IP Address
• Subnet Mask
• SMTP Server Name or IP Address
• Default Router IP Address
• Email Address
Make sure that the Internet lamp is ON. If not, press
1
2
3
repeatedly until display shows;
4
Enter the IP Address using the keypad. Press
to enter the period ".". (See Note 4)
Ex:
1 2 3
3
5
To continue setting other parameters, or press
return to standby.
(see Note 1) (see Note 2)
NOTE
1. To scroll the display to desired User Parameter in Step 3, press
2. The above IP Address fields require an entry to continue. If you wish to erase any of the above IP Addresses
(leave it Blank) and continue to the next step, press
IP Addresses do not require an entry to continue, just press
3. If the DNS Server is not available, change the setting of the Fax Parameter No. 161 (DNS Server) to "Invalid",
then enter the IP Address instead.
4. For convenience, you can use
used to enter an asterisk in other condition.
1 7 8 2 4 0
(see Note 3) (see Note 4)
to enter a period "." while programming IP Addresses only. Otherwise
to select the "INTERNET MODE".
SET MODE
ENTER NO. OR
1:USER PARAMETERS?
PRESS SET TO SELECT
IP ADDRESS
or
IP ADDRESS
123.178.240.3
SUBNET MASK
to
STOP
or .
CLEAR , then enter "0.0.0.0" and press
CLEAR and press
(1-4)
∨ ∧
SET . Other
SET to proceed.
is
25