General Setup - Draytek Vigor2920 Series User Manual

4 . 2 . 2 G e n e r a l
4 . 2 . 2 G e n e r a l
This page provides you the general settings for LAN. Click LAN to open the LAN settings
page and choose General Setup.
There are four subnets provided by the router which allow users to divide groups into different
subnets (LAN1 – LAN4). In addition, different subnets can link for each other by configuring
Inter-LAN Routing. At present, LAN1 setting is fixed with NAT mode only. LAN2 – LAN4
can be operated under NAT or Route mode. IP Routed Subnet can be operated under Route
mode.
Each item is explained as follows:
Item

General Setup-----

Index
Status
DHCP
IP Address
Details Page
Inter-LAN Routing
After finishing all the settings here, please click OK to save the configuration.
Vigor2920 Series User's Guide
S e t u p
S e t u p
Description
Allow to configure settings for each subnet respectively.
Display all of the LAN items.
Basically, LAN1 status is enabled in default. LAN2, LAN3,
LAN3 and IP Routed Subnet can be observed by checking the
box of Status.
LAN1 is configured with DHCP in default. If required, please
check the DHCP box for each LAN.
Display the IP address for each LAN item.
Click it to access into the setting page. Each LAN will have
different LAN configuration page. Each LAN must be
configured in different subnet.
Check the box to link two or more different subnets (LAN and
LAN).
94