Load-Balance Policy - Draytek Vigor2920 Series User Manual

Item
APN Name
Modem Initial String2
Modem Dial String
PPP Username
PPP Password
PPP Authentication
Index (1-15)
WAN Connection
Detection
After finishing all the settings here, please click OK to activate them.
4 . 1 . 4 L o a d - B a
4 . 1 . 4 L o a d - B a
This router supports the function of load balancing. It can assign traffic with protocol type, IP
address for specific host, a subnet of hosts, and port range to be allocated in WAN interface.
The user can assign traffic category and force it to go to dedicate network interface based on
the following web page setup. Twenty policies of load-balance are supported by this router.
Note: Load-Balance Policy is running only when more than one WAN interface is
activated.
Vigor2920 Series User's Guide
Description
APN means Access Point Name which is provided and
required by some ISPs. Type the name and click Apply.
The initial string 1 is shared with APN.
In some cases, users may need another initial AT command to
restrict 3G band or do any special settings.
Such value is used to dial through USB mode. Please use the
default value. If you have any question, please contact to your
ISP.
Type the PPP username (optional).
Type the PPP password (optional).
Selecting this option means the router will attempt to
authenticate dial-in users with the CHAP protocol first. If the
dial-in user does not support this protocol, it will fall back to
use the PAP protocol for authentication.
Set the PCs on LAN to work at certain time interval only. You
may choose up to 4 schedules out of the 15 schedules
pre-defined in Applications >> Schedule setup. The default
setting of this filed is blank and the function will always work.
Such function allows you to verify whether network
connection is alive or not through ARP Detect or Ping Detect.
Mode – Choose ARP Detect or Ping Detect for the system to
execute for WAN detection.
Ping IP – If you choose Ping Detect as detection mode, you
have to type IP address in this field for pinging.
TTL (Time to Live) – Displays value for your reference. TTL
value is set by telnet command.
l a n c e P o l i c y
l a n c e P o l i c y
86