General Setup - Draytek Vigor2130 Series User Manual

WEP (Wired Equivalent Privacy) is a legacy method to encrypt each frame transmitted via
radio using either a 64-bit or 128-bit key. Usually access point will preset a set of four keys
and it will communicate with each station using only one out of the four keys.
WPA (Wi-Fi Protected Access), the most dominating security mechanism in industry, is
separated into two categories: WPA-personal or called WPA Pre-Share Key (WPA/PSK), and
WPA-Enterprise or called WPA/802.1x.
In WPA-Personal, a pre-defined key is used for encryption during data transmission. WPA
applies Temporal Key Integrity Protocol (TKIP) for data encryption while WPA2 applies AES.
The WPA-Enterprise combines not only encryption but also authentication.
Since WEP has been proved vulnerable, you may consider using WPA for the most secure
connection. You should select the appropriate security mechanism according to your needs.
No matter which security suite you select, they all will enhance the over-the-air data
protection and /or privacy on your wireless network. The Vigor wireless router is very flexible
and can support multiple secure connections with both WEP and WPA at the same time.
Below shows the menu items for Wireless LAN.
4 . 8 . 2 G e n e r a l S e t u p
4 . 8 . 2 G e n e r a l S e t u p
By clicking the General Setup, a new web page will appear so that you could configure the
SSID and the wireless channel.
Please refer to the following figure for more information.
Enable Wireless LAN Check the box to enable the wireless function.
Vigor2130 Series User's Guide
176