Page 1
The information contained in this manual is subject to change without prior notice. The most current version of this manual is available on our official website at: www.dls.se Copyright c DLS Svenska AB. All rights reserved Copyright c DLS Svenska AB. All rights reserved...
Weight: 16 Kg ( 35 lbs) *Connect the AMPLIFIER ONE only to an AC source of the proper voltage. A label on the rear panel will indicate the correct voltage. Use of any other voltage will likely damage the unit and void the warranty Marking by the ”CE”...
We have spared no effort to ensure that it is one of the finest two-channel integrated amplifiers available in its class. We hope you enjoy listening to the AMPLIFIER ONE as much as the pride we have taken in creating this audio product.
AMPLIFIER ONE. Cleaning To clean the AMPLIFIER ONE, use only a soft tissue. Never apply abrasive cleaners to the surfa- ces of the unit. At no time should liquid cleaners be applied directly to the AMPLIFIER ONE, as direct application...
Front panel controls On the front panel you have two rotary controls and one push button. These three controls let you operate your AMPLIFIER ONE in daily use, or if you prefer, use the remote control R4U which is included.
4. Tape Out Fixed Level Output for external equipment. 5. Pre Out If you want to use your AMPLIFIER ONE as a pre-amp, just connect your power amplifier to the Pre Out with RCA connec- tors. 6. Output Connectors Speaker connectors.
IR Input Front Not in use NOTE: The AMPLIFIER ONE is equipped with a non-volatile memory that will remember all of the settings you have edited, (Volume, Input selection, Alias names, etc.) that you used before placing the unit into standby mode or switched the unit off totally by the mains switch.
Remote control R4U The same remote is used for both AMPLIFIER ONE and CD ONE. The functions used to control the amplifier are bold in the text below. Changes the AMPLIFIER ONE between ON and Standby mode...
Operating We recommend that you leave your AMPLIFIER ONE powered up at all times to maintain optimal performance. If you plan to be away from your home for a few days, powering off the amplifier may not be a bad idea. Don’t forget, if you do so, it will require several hours before it reaches its peak performance after you’ve powered up again!
(that is, non-original) packaging. Your dealer can order a new set of shipping materials for you if you need to ship your AMPLIFIER ONE and no longer have the original materials. There will be a charge for this service. We strongly recommend...