Rear Panel Connections - DLS AMPLIFIER ONE Owner's Manual

Rear panel connections

1. Mains Power Input and Fuse
2. Balanced Inputs
3. Unbalanced Inputs
4. Tape Out
5. Pre Out
6. Output Connectors
4
Plug the AC cord firmly into the AC jacket. Make sure you
connect to the proper voltage marked on your amplifier.
Connect the male end directly to an AC wall outlet.
Avoid use of an extension cord or power split since these often
degrade sound quality
The mains power switch turns the Amplifier totally off.
In the fuse box you will also find a spare main fuse. Please
check that it is the same value before switching fuse.
Intended to be used if your main source has XLR-outputs.
If your source/sources are not equipped with XLR-outputs,
please use the line inputs with RCA-connectors.
Line: 1, 2, 3 and Tape
Each input has the same input sensitivity and impedance.
They are compatible with any typical analogue line level source:
CD, DVD, MD, Laserdisc, VCR, DA-converter, Tape deck or
phono preamplifier.
Fixed Level Output for external equipment.
If you want to use your AMPLIFIER ONE as a pre-amp, just
connect your power amplifier to the Pre Out with RCA connec-
tors.
Speaker connectors. Marked + (Red) and – (Black).
Connect to the corresponding connectors on your loudspea-
kers.
6 5 4 3 2 1