Operating - DLS AMPLIFIER ONE Owner's Manual

Operating

We recommend that you leave your AMPLIFIER ONE powered up at all times to maintain optimal
performance. If you plan to be away from your home for a few days, powering off the amplifier may
not be a bad idea. Don't forget, if you do so, it will require several hours before it reaches its peak
performance after you've powered up again!
Turning on your AMPLIFIER ONE for the first time
When you turn the amplifier on for the first time, make sure that every cable is properly connected
to avoid any problems. Then turn on your amplifier in the following manner:
1. Turn on the main switch labelled POWER to the position "ON" at the rear side.
Make sure you connect to the proper voltage marked on your amplifier.
You will now see WARMING UP in the display window, wait a few seconds until
the message disappear.
2. Press the "STANDBY" button on the front side, the display window will
now display the Source and
3. Select input line.
4. Adjust the Volume to a reasonable listening level.
The R4U remote control
Functions used to control AMPLIFIER ONE are shown below, all the other buttons are only used
to control CD ONE
WARMING UP in the display window, wait a few seconds until WARMING UP
Source Source and Volume level.
1
3
5
7
9
10
11
12
7