Table Of Contents - DLS AMPLIFIER ONE Owner's Manual

Table of contents

Congratulations ................................
Unpacking .......................................
Quick setup guide ..............................
Introduction ......................................
Installation and placement ..................
Cleaning ..........................................
Front panel controls ...........................
Rear panels connections ....................
Settings ...........................................
Remote control .................................
Operating.........................................
Warranty..........................................
Obtaining service..............................
Troubleshooting.................................
Your own notes........................................
Technical specifications
Output power:
Minimum amplifier load:
Analogue inputs:
Input impedance:
Frequency response:
Signal to noise ratio:
Harmonic distortion (THD):
Channel separation:
AC power requirements*:
Power consumption@ idle:
Power consumption in Standby: 15 W
Dimensions (WxDxH):
Weight:
*Connect the AMPLIFIER ONE only to an AC source of the proper voltage. A label
on the rear panel will indicate the correct voltage. Use of any other voltage will
likely damage the unit and void the warranty
Marking by the "CE" symbol indicates compliance of this device with the EMC
(Electromagnetic Compatibility) and LVD (Low Voltage Directive) standards of
the European Community
This product must be returned to the separate col lec tion system for electronic
products. Do not dis po se this product together with general household waste.
2 x 100W @ 8 ohm, 2 x 180W @ 4 ohm
4 ohm
1 pair balanced (XLR), 4 pair unbalanced (RCA)
50 kohm
DC - 100kHz +/- 1 dB
> 106 dB
< 0,05% 20 Hz - 20 kHz
> 100 dB
120 V / 60 Hz or 240 V / 50 Hz
30 W
432 x 432 x 128 mm (17 x 17 x 5,04 inches)
16 Kg ( 35 lbs)
1
1
1
2
2
2
3
4
5
6-7
7
8
8
8
9