Front Panel Controls - DLS AMPLIFIER ONE Owner's Manual

Front panel controls

On the front panel you have two rotary controls and one push button. These three controls let you
operate your AMPLIFIER ONE in daily use, or if you prefer, use the remote control R4U which is
included.
1. Standby
2. Source
3. Display
4. Volume
1 2
Press this push button and the amplifier will turn on.
The display will show input source and amplifier level.
Push the button once more and the amplifier will go back
into Standby mode. The display will now be dark.
For best performance, the AMPLIFIER ONE should be left on,
or in the Standby mode at all times. When in Standby mode all
audio circuitry remains powered up to maintain optimal perfor-
mance. When switching back from Standby to the
Input Input and Input and Volume Volume level settings will be memorized from the Volume level settings will be memorized from the
previous listening session.
Use the left rotary control to select the input source.
The AMPLIFIER ONE has five inputs: 1 pair balanced (XLR),
and 4 pair unbalanced (RCA). If you want, you can rename the
input names in the display
More about this under chapter 5, Input Settings.
In normal mode the display shows selected input and volume
level. In setting mode the display will show actual status of the
settings. settings.
Use the right side rotary control to set output level (from mi-
ni mum 0, to maximum 85).
Standby to the Standby
3
Standby Standby mode all
on on mode, on mode,
4
3