Table of Contents
Advertisement
Welcome!
This owners manual is written in easy english and
uses a lot of drawings to simply the installation and
use of the above amplifiers.
Your DLS amplifiers must be installed correctly in
order to work well. This manual will show you how
to install the amplifier like a pro. Please read the
entire manual before beginning the installation.
Install the amplifier yourself if you feel confident
with our instructions and if you have the proper tools.
However if you feel unsure, turn over the installation
job to someone better suited to it.
Warranty Service
This amplifier is covered by warranty, depending on
the conditions in the country where it is sold. If the
amplifier is returned for service, please include the
original dated receipt with the product.
Technical Assistance
For technical assistance ask the shop where the
product was sold or the distributor in your very
country. Information can also be found on our WEB-
site www.dls.se
We follow a policy of continuous advancement in
development. For this reason all or part of specifica-
tions & designs may be changed without prior notice.
DECLARATION OF CONFORMITY
DLS amplifiers for vehicles are manufactured in
accordance with the EU directive EEC 95/54 (72/245/
EEC) and are marked with the approval number.
They are also marked in accordance with the WEEE-
directive 2002/96/EC.
The products are also produced in accordance with
the EU RoHS directive 2002/95/EC.
How to install and operate the
DLS amplifier models
CCi2 / CCi4
CCi44 / CCi44-40
CCi500 / CCi500-40
Contents
Features...............................................
Installation............................................
Routing Wires........................................
Tools and materials needed......................
Power and remote wiring............................. 3-4
Low & High level input wiring ......................
Input level control, BASS EQ, etc ...............
Features on each model .............................
CCi500 / CCI500-40 speaker wiring:
One or more subwoofers............................... 6
Front speakers........................................
Subwoofer.............................................
Four speakers........................................
Two subwoofers or a stereo speaker pair
connected in bridge mode .........................
Testing................................................
Troubleshooting....................................
Professional tips...................................
Specifications.......................................
This product must be returned to the
separate collection system for electronic
products. Do not dispose this product
together with general household waste.
DLS amplifiers are engineered by DLS Sweden,
a part of:
Winn Scandinavia AB
Elementvägen 15 - SE-702 27 Örebro - Sweden
Tel: +46 19 20 67 65 - E-mail: info@dls.se
www.dls.se
Sound tuned in England.
2
2
2
3
4
5
5
7
7
8
8
9
10
10
11
12
Advertisement
Table of Contents
Related Manuals for DLS CCi2
Summary of Contents for DLS CCi2
-
Page 1: Table Of Contents
They are also marked in accordance with the WEEE- Elementvägen 15 - SE-702 27 Örebro - Sweden directive 2002/96/EC. Tel: +46 19 20 67 65 - E-mail: info@dls.se The products are also produced in accordance with www.dls.se the EU RoHS directive 2002/95/EC. -
Page 2: Features
Amplifier location Important Allow air circulation around the amplifier. The DLS series of amplifiers have a compact design that allows great flexibility in mounting. You can mount it under a seat or in the trunk. When you select a location, do remember that the amplifier generates a lot of heat. -
Page 3: Tools And Materials Needed
Fuse values: on. If the red lamp doesn’t turn off, con- CCi2 and CCi4 : 40 A tact your local dealer for advice. CCi44 / CCi44-40... -
Page 4: Low & High Level Input Wiring
Most trunk-mount amplifiers need a 20 feet RCA cable ( appr 5 – 6 meters). Blue: CH4 - Connect to input socket CH1 / CH2 on CCi2. Yellow: CH4 + Or R/ L on CCi500 / Hi level input plug. -
Page 5: Input Level Control, Bass Eq, Etc
12 - 14 o’ clock. Set level control at 0 dB if you want High Pass filter (HPF) - CCi2 / CCi4 / CCi44 it to be inoperative. The high pass filter... -
Page 6: One Or More Subwoofers
CCi500 / CCi500-40 Speaker wiring CCi500 / CCi500-40 Two 4 ohm subwoofers One 4 ohm or 2 ohm subwoofer NOTE! NOTE! Subwoofer impedance can be 4 ohm or 2 ohm. Two 4 ohm subwoofers gives a 2 ohm load when Minimum amplifier load is 1 ohm, lower impedan- connected in this way. -
Page 7: Cci2 Speaker Wiring: Front Speakers
CCi2 Speaker wiring CCi2 One 4 ohm subwoofer bridged Two fullrange speakers to channel 1 / 2 NOTE! Minimum speaker impedance in bridged connec- tion is 4 ohm, this connection gives a 2 ohm load NOTE! with a 4 ohm subwoofer (the load is halved when Minimum amplifier load is 2 ohm in stereo mode, connected in bridge mode). -
Page 8: Cci4 / Cci44 / Cci44-40 Speaker Wiring: Four Speakers
CCi4 / CCi44 / CCi44-40 Speaker wiring CCi4 / CCi44 / CCi44-40 1. Four fullrange speakers. One pair 2. Two fullrange speakers and one subwoofer in front and one pair in rear. 4 / CC 44 (3-channel mode). bridged to CC Front speakers Subwoofer... -
Page 9: Connected In Bridge Mode
CCi4 / CCi44 / CCi44-40 Speaker wiring CCi4 / CCi44 / CCi44-40 3. Two subwoofers or stereo speakers brid- Filter settings front channels CH 1 / 2 ged to CC 4 / CC Filter settings rear channels CH 3 / 4 The low pass filter is mostly used for sub- woofers. -
Page 10: Testing
4. Check the amplifier protection fuses. Are these broken change to new ones with the same value. If short circuiting continues, contact your local DLS dealer. A fault may exist in the amplifier. 5. To start the amplifier requires a remote voltage of Test power wiring 9-15 volt. -
Page 11: Professional Tips
If noise remains regardless of cable position, try to use so called Quasi-balanced signal NOTE! Tweeters can not be tested this way, dou- cables. DLS PRO-cables are Quasibalanced. ble check the connections instead. Professional Tip: Professional Tip: Installing in trunk... -
Page 12: Specifications
Internal cooling fan Power terminal size 2 AWG / 33 mm Speaker terminal size 7 AWG / 10 mm Weight 2,4 kg CCi2 CCi4 CCi44 / CCi44-40 Number of channels Amplifier class Power output RMS in 4 ohm 2 x 110 W...