Operation - Dimplex RWF-DG Owner's Manual

Operation

The controls are located on the bottom surface of the
Sahara fi replace on the right side (Figure 7).
Figure 7
Control Location
Bottom View
A. Main On/Off Switch
The switch has two On positions marked with
"Manual".
The "Manual" position is for manual operation. In this
position the built-in remote control is by-passed.
The position is for operating the unit with the
provided remote control.
When in position the unit is operated with the ON
and OFF buttons of the remote control.
When the switch is in the center position the unit is off.
B. Heater On/Off Switch
The Heater On/Off Switch supplies power to the
heater fan and the heater element. When the switch is
in the On position the heater operates if the thermostat
calls for heat.
C. Heater Thermostat Control
To adjust the temperature to your individual
requirements, turn the thermostat control clockwise
all the way to turn on the heater. When the room
reaches the desired temperature, turn the thermostat
knob counter clockwise until you hear a click. Leave in
this position to maintain the room temperature at this
setting. For additional heat, turn clockwise until you
hear the click again and the heater will turn on.
Resetting The Temperature Cutoff Switch
Should the heater overheat, an automatic cut out will
turn the heater off and it will not come back on without
being reset. It can be reset by switching the Main On/
Off Switch to Off and waiting fi ve (5) minutes before
Front View
switching the unit back on.
Remote Operation
The fi replace is supplied with an integrated on/off
remote control.
!
To operate, push the ON button to turn fi replace on,
A B C
push the OFF button to turn the fi replace off.
Battery Replacement
and
To replace the battery:
transmitter (Figure 8).
the battery holder.
Figure 8
OFF
Button
Battery
Cover
CAUTION: If you need to continuously reset the
heater, unplug the unit and call Dimplex customer
service at 1-888-DIMPLEX (1-888-346-7539).
NOTE: Ensure that the fi replace Main On/Off
Switch is set to the Remote Control
position).
Slide battery cover open on the hand held
Correctly install one (1) 12 Volt (A23) battery in
Close the battery cover.
ON
Button
Battery
setting (up
7