DigiDesign 003 Family Setup Manual page 130

To set the MIDI channel:
Turn the rotary encoder for channel 3 (Chan)
until the channel you want is displayed (1–16).
To set the CC#:
Turn the rotary encoder for channel 4 (CC#)
until the CC value you want is displayed
(0–127).
Any control can be set to no assignment ("No
Asgn") by turning the encoder below 0.
For switches, turn the rotary encoder past 127 to
select MMC transport control messages: Re-
wind, Fast Forward, Stop, Play, and Record (RW,
FF, ST, PL, and RC).
To set the High and Low MIDI values (controller
range):
Turn the rotary encoder for channel 5 to set a
1
Minimum MIDI Value (0–127).
Turn the rotary encoder for channel 6 to set a
2
Maximum MIDI Value (0–127).
To name a control:
Select the control you want to name.
1
Turn the rotary encoder for channel 8 (Name).
2
This displays the Name parameters in the LCD.
Turn the rotary encoder for channel 2 to scroll
3
and select lower-case, upper-case, or numerics
for the first character of the custom name.
When the desired character is displayed, turn
4
the rotary encoder for channel 1 to move to the
next character. The cursor flashes for the se-
lected character.
Repeat steps 3–4 for the remaining characters
5
of the control name.
120 003 Family Setup Guide
When you are done, do one of the following:
6
• To confirm the new control name, select
OK by pressing the Master Bypass switch.
– or –
• To cancel without renaming the control,
select Cancel by pressing the ESC switch.
To exit MIDI Edit mode:
Press the flashing MIDI Edit switch. The MIDI
Edit switch LED stops flashing.
You must manually save changes to MIDI Map
presets. If you do not, your changes will be lost
when you recall a different MIDI Map preset or
power off 003. For information on saving pre-
sets, see "Saving MIDI Map Presets" on
page 121.
Momentary or Latch Mode
Switches can be set to Momentary or Latch
mode.
Momentary Mode The specified High MIDI
Value (HiVal) is transmitted when the switch is
pressed, and the specified Low MIDI Value
(LoVal) is transmitted when the switch is re-
leased.
Latch Mode The output of the switch toggles be-
tween the specified High and Low MIDI values
when pressed.
To program a switch for Momentary or Latch
mode:
Enter MIDI Edit mode.
1
Select the switch you want to edit.
2
Turn the rotary encoder for channel 7 (Mode)
3
to select Latch or Momnt (momentary).