DigiDesign 003 Family Setup Manual page 103

Hold Shift (Add) and press the Channel Select
3
switch for an unselected (unlit) track.
All tracks between the first track selected and the
additional track will also be selected.
To remove subsequent tracks in range of selected
tracks:
Press the Pan switch to put 003 in Pan View.
1
Hold Shift (Add) and press the Channel Select
2
switch for a selected (lit) track in the middle (or
beginning) of a range.
All tracks following the selected track will be de-
selected.
To select all tracks:
Press the Pan switch to put 003 in Pan View.
1
Hold Opt/Alt All and press the Channel Select
2
switch for any unselected (unlit) track.
To deselect all tracks:
Press the Pan switch to put 003 in Pan View.
1
Hold Opt/Alt All and press the Channel Select
2
switch for any selected (lit) track.
To select or deselect noncontiguous tracks:
Press the Pan switch to put 003 in Pan View.
1
Do one of the following:
2
• In Pan View, hold Command/Ctrl and
press the Channel Select switch for an un-
selected (unlit) tracks to select them.
– or –
• In Pan View, hold Command/Ctrl and
press the Channel Select switch for any se-
lected (lit) tracks to deselect them.
Renaming Tracks
To rename a track:
Press the Pan switch to put 003 in Pan View.
1
Double-press the Channel Select switch for
2
the track you want to rename.
Enter the new name in the Track Name/Com-
3
ments dialog.
Click Enter.
4
Send View Workflows
When the Send switch is enabled (lit), 003 is in
Send View. In this view, you can adjust send
level with the rotary encoders, toggle pre- and
post-fader operation of sends, and assign sends
in Assign mode.
For information on assigning sends in As-
sign mode, see "Assigning Pro Tools Paths
(Input, Output, Sends, Inserts)" on
page 102.
To display a Send position (A–J):
Press the Send switch to put 003 in Send View.
1
Press the Insert/Send Position switch that cor-
2
responds to the send position that you want to
adjust. The five Console View switches are
dual-function (A/F, B/G, C/H, D/I, E/J). Press the
switch to toggle from the current send to the
corresponding one (such as Send A to F or Send
F to A).
To adjust send levels:
Press the Send switch to put 003 in Send View.
1
Press the Insert/Send Position switch (A/F,
2
B/G, C/H, D/I, E/J) that corresponds to the send
position that you want to adjust.
Adjust a channel's send level by turning its ro-
3
tary encoder.
Chapter 11: Pro Tools Mode with 003 93