Working With Memory Locations; Controlling Track Display On The Control Surface - DigiDesign 003 Family Setup Manual

Undoing Pro Tools Operations
You can undo Pro Tools operations from 003.
(See the Pro Tools Reference Guide for details on
multiple undo capabilities.)
To undo an action:
Press the Undo switch.
To redo an action:
Hold Shift (Add) and Command/Crtl and
press the Undo switch.
Working With Memory
Locations
Pro Tools Memory Locations (Markers) can be
created directly from 003 during playback or
while the Transport is stopped.
To create a Memory Location:
Cue Pro Tools to the desired location, or begin
1
playback.
At the desired location, press Enter (located
2
among the switches above and to the left of the
Navigation keys).
Use the mouse to configure the Memory Loca-
3
tion dialog onscreen.
Press Enter again to save, or press Undo to can-
4
cel.
To open (or close) the Memory Location window:
Hold Shift (Add) and press the Mem Loc
switch.
To display Memory Locations:
Press the Mem Loc switch.
1
108 003 Family Setup Guide
When the switch is enabled (flashing), the LCD
shows the first eight Memory Locations in the
bottom row of the LCD display.
To display any additional pages of Memory
2
Locations, press the Left and Right Page
switches.
The Left or Right Page switch flashes when
an additional page is available.
To recall a Memory Location:
Press the Mem Loc switch to display Memory
1
Locations in the LCD display.
To display any additional pages of Memory
2
Locations, press the Left and Right Page
switches.
Do one of the following:
3
• Press the Channel Select switch that corre-
sponds to the Memory Location.
– or –
• To return to the previous view without se-
lecting a Memory Location, press Mem Loc
again, or any of the Console or Channel
View switches.
Controlling Track Display on
the Control Surface
Using Flip Mode
In Flip mode, control assignments are trans-
ferred from the rotary encoders to the corre-
sponding channel faders.
To transfer controls from the rotary encoders to
the touch-sensitive faders:
Press the Flip switch. This switch flashes when
Flip mode is activated.