Volvo XC90 Owner's Manual page 171

07 Wheels and tyres
Emergency puncture repair
Variant 2
Overview
10
07
1. Decal, maximum permitted speed
2. Switch
3. Cable
4. Bottle holder (orange cap)
5. Protective cap
6. Pressure reducing valve
170
7. Air hose
8. Sealing fluid bottle
9. Pressure gauge
10. Gloves
Inflating the tyres
The car's original tyres can be inflated by the
compressor.
1. The compressor must be switched off.
Make sure that the switch is in position 0
and locate the cable and air hose.
2. Unscrew the wheel's dust cap and
screw in the air hose valve connection
to the bottom of the thread on the
tyre's air valve.
3. Connect the cable to one of the car's
12 V sockets and start the car.
WARNING
Inhaling car exhaust fumes can result in
danger to life. Never leave the engine run-
ning in enclosed areas or areas that lack
sufficient ventilation.
4. Start the compressor by flicking the
switch to position I.
5. Inflate the tyre to the pressure specified
on the tyre pressure decal. (Release air
using the pressure reducing valve if the
tyre pressure is too high.)
IMPORTANT
Risk of overheating. The compressor must
not run for more than 10 minutes.
6. Switch off the compressor. Detach the
air hose and cable.
7. Refit the dust cap.