Volvo XC90 Owner's Manual page 160

Spare wheel – refitting
It is best to have two people put the spare
wheel back in place. One person to crank
and the other to guide the wheel.
– Crank out the cable and place its anchor
in the centre hole of the wheel.
– Slowly crank (clockwise) the cable in a bit.
– Angle the wheel so that it comes in over
the exhaust system.
– Hold down the rear edge of the wheel
while cranking it in.
– Place the wheel above the rear axle,
against the floor.
– Crank to the stop point.
– Check that the wheel is properly secured.
WARNING
Check that the right mounting points are
being used. A production anchorage with
pin is located between the jacking points.
This is not strong enough to use to lift the
car. If you are unsure about the location of
the jacking points, contact an authorised
Volvo workshop. An incorrectly fitted jack
could damage the door and body.
07 Wheels and tyres
Warning triangle and spare wheel
07
159