Volvo XC90 Owner's Manual page 162

Fitting the wheel
– Clean the contract surfaces on the wheel
and hub.
– Fit the wheel. Screw the wheel nuts.
– Lower the car so that the wheel cannot
rotate.
– Tighten the wheel bolts alternately and in
torque steps. Tightening torque: 140 Nm
(14.0 kpm). It is important that they are
tightened to the correct torque. Check
with a torque wrench.
– Screw the jack all the way down before
returning it to the cargo area. Then secure
it in place.
– Check that the new tyre has the correct
amount of pressure.
NOTE
There are two different types of wheel bolts
depending on whether or not your car has
steel or aluminium rims; bolts used with alu-
minium rims have a loose, rotating ring.
Bolts used with steel rims have no rotating
ring.
Make sure to use the correct type of bolt. If
you are unsure, check with the nearest Volvo
workshop.
IMPORTANT
If TPMS is specified then the tyres must be
calibrated after fitting. Read "Adjusting tyre
pressure", see page 162.
07 Wheels and tyres
Changing wheels
07
161