Volvo XC90 Owner's Manual page 159

07 Wheels and tyres
Warning triangle and spare wheel
Spare wheel – removing
The spare wheel is located under the car. The
1 1
jack , tool kit and crank are located under
the floor hatch. The crank is in two parts. One
part is in the tool kit and the other is under
the tool kit.
07
NOTE
There is a puller spanner in the tool kit to re-
move the hub cap (certain wheel options).
The location of the jack depends on whether
the car seats seven (1) or five (2).
1
Certain variants and markets
158
Proceed as follows to release the spare
wheel:
– Lower the bottom of the tailgate and lift up
the floor hatch in the cargo area.
– Take the two parts of the crank and as-
semble.
– Fit the crank in the winch.
– Loosen the tyre by cranking anticlockwise
until you reach the stop.
– Release the wheel from the cable and
rewind up the cable clockwise.
NOTE
The cable could damage the car if it hangs
free while driving.
– Place the punctured tyre in the cargo area.
The tool kit contains a plastic bag for the
tyre.
NOTE
The spot under the car is only intended for
the car's original spare wheel. Do not place
any other wheels there.