Visonic POWERMAX Programming Manual page 6

5 . 2 4 h s i l e n t
F. Click <OK> once more to confirm. The "Happy Tune"
will sound, and your selection will be memorized. The
display will then change to:
Z 0 7 : N A M E
G . At this point, enter the serial number of the zone name
you wish to attach to zone No. 7 from the list of 29
available names (see list in Figure 3).
Note: If you click <OK> without entering a number, the
display will show the current name of the selected
zone, with a dark box at the far right. You may then
review all names by clicking <NEXT> repeatedly.
H. If you enter a number (say 13), the display will read:
F r o n t d o o r
I. Click <OK> to accept this name - a dark box will appear
at the far right. Click <OK> again to confirm. The
"Happy Tune" will sound, your selection will be saved
and the display will change to:
Z 0 7 : C H I M E
J. Click <OK>. You are about to determine whether this
zone will be a chime zone or not. The display will read:
Zone No.
Default
1 Delay 1
2 Delay 1
3 Delay 2
4 Perimeter
5 Perimeter
6 Interior
7 Interior
8 Perimeter
9 Perimeter
10 Perimeter
11 Interior
12 Interior
13 Perimeter
14 Perimeter
15 Interior
16 Perimeter
17 Perimeter
18 Perimeter
19 Perimeter
20 Fire
21 Fire
22 Emergency
23 Emergency
24 24 h / silent
25 24 h / silent
26 24 h / audible
27 24 h / audible
28 non-alarm
29 non-alarm
30 non-alarm
* Note: All zones are non-chime by default. Enter your own choice in the last column and program accordingly.
6
_
DEFAULT AND PROGRAMMED ZONE DEFINITIONS
Zone Type
Programmed
c h i m e o n
or: chime off
You can toggle the display between CHIME ON and
CHIME OFF by clicking <NEXT>.
K. Click <OK> once if you approve the already selected
option - the "Happy Tune" will sound. Alternatively, click
<OK> twice while the other option is viewed. The
"Happy Tune" will sound and the display will revert to:
Z o n e N o . 0 7
L . From this point on, you may continue in several
different directions:
- Click <NEXT> to go up (8
- Click <BACK> to go down (6
Repeat Steps C through K above for all
other zones that you plan to use.
• To return to the main menu, click
<AWAY>. This will get you back to:
< O K > T O E X I T
You may now review and select any other
mode on the installer's menu (by clicking
<NEXT> or <BACK>).
Zone Name
Default
Front door
Garage
Garage door
Back door
Child room
Office
Dining room
Dining room
Kitchen
Living Room
Living Room
Bedroom
Bedroom
Guest Room
Master Bedroom
Master Bedroom
Laundry room
Master Bathroom
Basement
Fire
Fire
Emergency
Emergency
Basement
Office
Attic
Den
Yard
Hall
Utility room
%
Programmed
9 10.....)
%
5 4.....)
% %
Chime Y/N? *
DE5450P