Wiring Diagram - Vinotemp WINE-MATE VINO3500HZD Service Manual

3. Set the ohmmeter scale to the lowest setting. Touch and hold one
ohmmeter probe to one of the wire terminals, then touch and hold the
other probe to the other wire.
4. The ohmmeter should show a reading of tens ohms.
5. Reconnect the wires to the proper terminals as previously marked.
B. Live voltage
1. The WINEMATE unit needs to be plugged in and turned on.
2. Locate the black and white wires from the fan motor being tested and
follow them back to the terminal block.
3. Set the voltmeter to the AC 200 scale.
4. Touch and hold one voltmeter probe to one of the wire terminals, then
touch and hold the other probe to the other wire.
5. The voltmeter should show a reading of 115 volts.
II. Wiring Diagram
Figure 3-5
- 18 -