Disconnecting A Device From The Host - NEC Express5800/320Ma User Manual

Configuring and Connecting Remote Storage Devices
3. If a System Settings Change message appears, indicating that the operating
system has finished installing new devices and asking if you want to restart the
computer, click No. You do not need to restart the computer.
4. When a message in the main AVR window indicates that a high-speed USB device
is plugged into a non-high-speed USB hub, ignore the message and close it.
The connected device is available on the server as a floppy disk drive or CD drive.
Related Topics
•
"Configuring and Connecting Remote Storage Devices"
•

"Disconnecting a Device from the Host"

Disconnecting a Device from the Host
Use the following procedure to disconnect a local device from the Express5800/320Ma
system.
!
To disconnect the device from the host
1. Start an Advanced Video Redirection (AVR) session
server.
2. In AVR, on the server's taskbar at the bottom of the window, double-click the Safely
Remove Hardware icon (keyboard with green arrow)
The Safely Remove Hardware dialog box opens.
3. In the Hardware devices box, select USB Mass Storage Device and click Stop.
4. On the Stop a Hardware device dialog box, select USB Mass Storage Device
and click OK.
5. If you connected multiple devices, repeat steps 3 and 4 for each configured device;
otherwise, go to step 6.
6. On the Safely Remove Hardware dialog box, click Close.
7. In the VTM console
Connect to Host I/F check box. A message warns you that data corruption can
result if data transfers are occurring.
8. Click OK. The device is safely disconnected from the host.
4-14 Express5800/320Ma: Virtual Technician Module User's Guide
C A U T I O N
Failure to use this procedure can cause unpredictable
results in the operating system.
on the Remote Storage Settings dialog box, clear the
to display and control the
.