Toshiba Strata CIX Installation And Maintenance Manual page 26

Media Application Server Installation
MicroMAS Installation
Step 6. Install Voice/Fax
Board(s)
The 1U MAS system supports one fax
modem board per system for a maximum of
8 fax modem ports.
1. Loosen the riser retaining bar by pulling
on the release tab and lifting the Bar to
unlock it (shown right).
2. Remove the PCI riser screw, then
remove the PCI riser by pulling the riser
upwards with the green strap.
3. Insert the edge connector of the first
board into the PCI 1 slot (see
10). Apply pressure only to the top edge
of the board, and gently rock the board
back and forth to seat the edge
connector into the slot.
4. Insert the second board into the PCI 2 slot.
Note
PCI Riser
Figure 1 - 10 MicroMAS Internal View 2
Step 7. Reinstall Riser
1. Reinstall the PCI riser in the chassis. Align the PCI slot and press down to secure the PCI riser
assembly.
2. Insert the riser retaining bar and press gently to lock into place.
3. Secure the riser to the chassis by screwing in the screw taken out in
Board(s).
1-16
A Dialogic Voice board can be installed in the PCI 1 (top) slot with no modification. To
install a fax-Modem card into the PCI 1 card slot the green strap must first be removed
from the riser. The fax-modem card can be installed in the PCI 2 slot without modification.
002-MM
Figure 1 -
Retaining Bar
Figure 1 - 9
Riser
Release Tab
MicroMAS Internal View 1
Power Supply
Retaining Bar
PCI 1 Card
PCI 2 Card
CPU Fan
RAM Slot
Chassis Fan
Step 6.Install Voice/Fax
STRATA CIX MAS INSTALLATION 06/09
001-MM