Toshiba Strata CIX Installation And Maintenance Manual page 25

Step 2. Network Connection
The MicroMAS requires a static IP Address. The MicroMAS and the Strata CIX (xCTU processor
card) should be the same network segment.
Since MicroMAS-H has a VoIP connection to the MIPU/LIPU, then the supporting MIPU/LIPU must
have an IP address that can be successfully pinged by the MicroMAS.
A MIPU/LIPU card's IP Address must be accessible by all IP devices (IP Telephones (IPT),
MicroMAS). If IPT stations are going to be placed on the public internet or Strata Net IP will be run
on the public network without a Virtual Private Network (VPN), the MIPU/LIPU should have a public
IP address. The MicroMAS and CIX must be physically installed first. Connect up the MicroMAS.
Insert the IP circuit cards into the CIX cabinets. Connect the IP cables. When all of the cables are
connected proceed to the next step of setup.
Step 3. Verify PC Operation
Notes
• Steps 2~5 are required only if you have purchased a Voice board. They are not required for
ACD, etc.
• This step verifies the unit is operational before installing voice boards.
1. Set the Voltage Selector Switch, located on the back panel, to an input power source of either
115VAC default or 220VAC (50-60 Hz), depending upon the available input power.
2. Plug-in the power cable to the rear of the unit and to the UPS.
3. Connect the monitor, keyboard and mouse. See
keyboard and mouse connections on the MicroMAS.
4. Power up the unit. If the Windows® XP logon screen does not display, check the connections.
At this point the installation is partitioned.
• If you are installing a MicroMAS-D, that uses Dialogic analog port voice boards for
connectivity to the CIX or installing a Fax modem card, proceed to the next step.
• If you are installing a MicroMAS-H, that uses HMP for IP connectivity to a CIX MIPU/LIPU
card, proceed to step 13.
Step 4. Remove Cover
1. Once the unit is operational, shut down Windows, turn the power off and remove the power
cable.
2. Remove the two screws from the upper left and right corners of the back of the server. Pull the
cover off using the build-in handle.
Step 5. Unpack Voice / Fax-modem Boards

Remove the Dialogic voice (Dialogic part number D4PCIUF/S) and/or MultiTech System Fax-
modem (MultiTech part number MT5634ZPX-PCI) board(s) to be installed in this system from
the shipping boxes.
Note MicroMAS only supports half-length PCI boards.
Strata CIX MAS Installation 06/09
Media Application Server Installation
Figure 1 - 11 on Page 17
MicroMAS Installation
for the monitor,
1-15