Media Application Server Installation
Front Panel Detail
6. Reassemble card cage by reversing steps 1 through 3. Ensure that the locating tabs on the
card cage slide into place at the bottom, front of the chassis.
Front Panel Detail
The AC Power cord connects on the rear panel of the MAS. All other connections are on the front
panel.
Mouse connector
Keyboard connector
Dual Redundant Power Supplies Installation
Use the following procedure to remove the standard power supply and install the optional dual,
redundant power supply assembly.
1. Shut down the system. When the system has completely shut down, the fans have stopped,
remove the AC power cord from the back of the MAS chassis.
2. Remove the top cover of the 2U MAS. Retaining screws can be found on the top front of the
cover and on the side of the chassis.
3. Access the bottom of the cabinet. Remove two power supply bracket screws. The screws are
approximately six inches (15.5 cm) from the rear edge of the cabinet and about 5.75 inches
(12.25 cm) apart.
4. Carefully cut the cable ties securing the power supply cables to the bottom of the cabinet.
5. Remove the PCI card cage from the chassis.
6. Remove the DVD drive assembly. The cables are long enough to set the DVD drive out of the
way. It is necessary to remove the drive to access the power connection to the motherboard.
1-10
Hard Disk Drive
Power
Activity
Monitor
1 GB LAN connector
CPU Reset Button
USB Connectors
STRATA CIX MAS INSTALLATION 06/09