Getting Started; Prepare Marker For Air Supply Cylinder Installation; Air Supply Cylinder Installation - Tippmann CUSTOM PRO Owner's Manual

Safety Is Your Responsibility (continued from page 5)
• Do not field strip or otherwise disassemble this marker while
it is pressurized with air supply.
E
• Dress appropriately when playing the game of paintball. Avoid
exposing any skin when playing the game of paintball. Even
N
a light layer will absorb some of the impact and protect you
G
from the paintballs.
• Keep exposed skin away from escaping gas when installing
L
or removing air supply cylinder or if the marker or air supply is
I
leaking. Compressed air, CO
cold and can cause frostbite under certain conditions.
S
• Use only .68 caliber paintballs, never load or fire any foreign
H
objects.
• Avoid alcoholic beverages before and during the use of this
marker. Handling markers while under the influence of drugs
or alcohol is a criminal disregard for public safety.
• Avoid shooting an opponent at point blank, 6 feet or less.
• Familiarize yourself with instructions listed on air supply
cylinder or adaptor. Contact the air supply cylinder or adaptor
manufacturer with any questions.
• Always measure your marker's velocity before playing
paintball and never shoot at velocities in excess of 300 feet
per second (see instructions on page 7).

Getting Started

STEP 1) Prepare Marker for Air Supply Cylinder Installation
• For Model: Custom Pro
battery (see instructions on page 9 before performing STEP 2.
• For Custom Pro
STEP 2) Air Supply Cylinder Installation
• Do not pressurize a partially assembled paintball marker.
• First install barrel sleeve (see instructions on page 2).
• Next put trigger safety in Safe Mode (see instructions on page 4).
• Next you need to cock the marker by sliding the bolt handle
all the way back until it locks into place. Always keep marker
in the cocked position when air supply is attached to marker.
This will help prevent an accidental discharge.
• To install the air supply cylinder, lubricate the cylinder valve
o-ring with a little gun oil then insert the cylinder valve end
into the air supply adapter at the back end of the marker grip.
Twist the cylinder clockwise into the marker until it stops. Adjust
the butt plate if necessary. Your marker is ready to fire once
you switch to Fire Mode from Safe Mode. If the tank is full and
you do not hear the air supply engage, the pin valve could be
too short or the pin valve seal is damaged.
TM With E-GRIP
TM and Custom Pro
6
, and nitrogen gasses are very
2
TM - You must first install
TM Response
Getting Started (continued on page 7)
TM go to STEP 2.