Warning/Caution; Warning/Caution Barrel Sleeve Installation - Tippmann CUSTOM PRO Owner's Manual

E
THIS IS NOT A TOY. MISUSE MAY CAUSE SERIOUS
N
INJURY OR DEATH. EYE, FACE AND EAR PROTECTION
DESIGNED FOR PAINTBALL MUST BE WORN BY THE
G
USER AND ANY PERSON WITHIN RANGE.
L
RECOMMEND AT LEAST 18 YEARS OLD TO PURCHASE.
I
PERSONS UNDER 18 MUST HAVE ADULT SUPERVISION
WHEN USING THIS PRODUCT. READ THE OWNER'S
S
MANUAL BEFORE USING THIS PRODUCT.
H
• EXCEPT WHEN YOUR MARKER IS IN USE, ALWAYS MAKE
SURE THAT THE TRIGGER SAFETY IS IN SAFE MODE (SEE
INSTRUCTIONS ON PAGE 4), AND THE BARREL SLEEVE IS
PROPERLY INSTALLED ON YOUR MARKER AS SHOWN BELOW.
1) SLIDE BARREL INTO SLEEVE AND LOOP CORD OVER TOP
OF RECEIVER AND POSITION AT BACK OF GRIP AS SHOWN
BELOW.
barrel
sleeve
2) PINCH CORD LENGTH
ADJUSTOR BUTTON AND
HOLD TO BACK OF GRIP AS
YOU PULL CORD THROUGH IT UNTIL ADJUSTOR IS SNUG
AGAINST BACK OF GRIP, THEN RELEASE BUTTON.
3) CHECK TO BE SURE YOU LEAVE ENOUGH CORD
ELASTICITY TO PULL CORD/ADJUSTOR UP OVER TOP OF
MARKER TO REMOVE BARREL SLEEVE FOR FIRING.
4) AFTER
CORD
LENGTH IS ADJUSTED,
LOCK CORD LENGTH BY TYING
A KNOT IN THE CORD AGAINST
THE BACK OF THE ADJUSTOR AS SHOWN.
WARNING
WARNING
BARREL SLEEVE INSTALLATION
barrel
sleeve
2
WE
CORD
LENGTH
ADJUSTOR
BUTTON