Sunbeam Espresso Vita EM6200 Instruction Booklet page 33

Advanced programming options (continued)
Steam Thermoblock Temperature
The steam temperature of this espresso
machine has been calibrated to deliver a
powerful and dry steam for texturing milk.
The temperature of the steam can be
modified in increments of 2°C up and down
should it be desired.
To do this you need to follow the instructions
below:
1.Insert the power cord into a 230-240V AC
power outlet and switch the power 'ON'.
Note: Although the espresso machine is ON
at the power outlet ensure that the actual
espresso machine power is 'OFF'. Therefore
no lights will be illuminated on the espresso
machine control panel.
2.Press and hold down the 'HOT WATER/
STEAM' button.
3.While still holding down the 'HOT WATER/
STEAM' button briefly press the 'POWER'
button and release all buttons.
Note: This activates the programmability of
the Steam Thermoblock Temperature and
to signal this a series of beeps will follow
and the 'HOT WATER/STEAM' button LED
will light up. Additionally the 'SINGLE' and
'DOUBLE' button LEDS will start to flash.
Note: A series of beeps will indicate the
current setting.
4.Press the 'SINGLE' button to decrease the
steam temperature or to increase the steam
temperature press the 'DOUBLE' button.
Please refer to the chart below.
Steam Temperature Programming
Setting
+3 (Factory Setting) 3 Short Beeps
+2
+1
0
-1
-2
-3
5.Once you have selected the desired
temperature, press and hold the 'HOT
WATER/STEAM' button to save the new
setting. A single long beep will sound to
indicate the new setting has been saved.
The espresso machine will then turn on to
'READY MODE'.
Remember: If you do not press the 'HOT
WATER/STEAM' button within 30 seconds
the program will return to the Factory Setting
and the espresso machine will then power on
and begin heating up.
Beep Sequence
2 Short Beeps
1 Short Beep
1 Short Beep and 1 Long Beep
1 Long Beep
2 Long Beeps
3 Long Beeps
31