Table of Contents
Advertisement
Resetting to the factory default configuration
Resetting to the factory default configuration
Installing FortiBridge unit firmware
30
config system admin
edit <admin_name_str>
set password <password>
set accprofile prof_admin
end
For example:
config system admin
edit new_admin
set password p8ssw0rd
set accprofile prof_admin
end
For more information about configuring administrators see
page
59.
Use the following procedure to reset the FortiBridge unit to the factory default
configuration. You might want to rest the FortiBridge to the factory default
condition if the FortiBridge unit is not functioning as expected and you would like
to re-start the configuration process. Resetting to the factory default configuration
resets all configuration changes that you have made, including the management
IP address. See
"Factory default configuration" on page
To reset to factory default configuration from the FortiBridge front panel
1
Press and release the Factory reset button.
Use a pen or other pointed object to press the button.
After a few seconds the FortiBridge unit restarts; reset to the factory default
configuration. You can now re-configure the FortiBridge unit.
To reset to factory defaults from the FortiBridge CLI
1
Log into the CLI.
2
Enter the following command:
execute factoryreset
3
Type y and press Enter.
After a few seconds the FortiBridge unit restarts; reset to the factory default
configuration. You can now re-configure the FortiBridge unit.
Select a procedure from
Before beginning any of the procedures in this section, you must have the
FortiBridge firmware image file that you are going to install on the FortiBridge unit.
During these procedures you are required to enter the name of the firmware
image file.
Table 8
to install FortiBridge unit firmware.
FortiBridge Version 3.0 Administration Guide
Setting up FortiBridge units
"system admin" on
22.
09-30000-0163-20061109
Advertisement
Table of Contents
