System Fail_Close - Fortinet Version 3.0 Administration Manual

Fortinet bridge administration guide
Hide thumbs Also See for Version 3.0:
Table of Contents

Advertisement

system fail_close

system fail_close
Use this command to configure the fail close feature.
Command syntax pattern
config system fail_close
end
config system fail_close
end
get system fail_close
show system fail_close
Keywords and variables
status {disable |
fail_close |
fail_bypass
threshold
<seconds_integer>
64
set <keyword> <variable>
unset <keyword>
Description
The fail_bypass option is only available on the
FBG-1000F.
When the FortiBridge detects an upstream or downstream
}
network disconnection (whether due to a cut/disconnected
cable, failure of the connected device, or failure of the
FortiBridge unit's own interface), it will bring down its own
network interface after waiting the amount of time set for
the threshold variable. If the fail close status is set to
fail_close and a switch connected to EXT1 fails, the
FortiBridge would bring down its own INT1. This way, the
device connected to INT1 will be able to determine there is
a problem Similarly, if a device connected to INT1 fails, the
FortiBridge would bring down its own EXT1.
When the problem is corrected, the FortiBridge will enable
its own network interface after waiting the amount of time
set for the threshold variable.
Some early FBG-1000 units will return an Not supported
by this hardware error when this command is invoked. This
is normal as hardware support for fail_close was only
added in later units.
When using a FBG-1000F, some fiber-connected
equipment doesn't properly detect the status of a
FortiBridge interface brought down by the fail_close
option. To prevent this problem, use fail_bypass
instead. If a network problem is detected with
fail_bypass set, the FortiBridge will switch to bypass
mode. This way, the network devices can detect the
problem directly through the FortiBridge. Note that
fail_bypass causes the FortiBridge to remove itself
from the network when a problem is detected so manual
intervention is required to switch back to normal mode.
Enter how long, in seconds, the FortiBridge will wait after
detecting a network problem before activating the fail close
feature. Except when fail_bypass is set, the FortiBridge
will wait the specified time before deactivating the fail close
feature when the problem is corrected.
config CLI commands
Default
disable
3
FortiBridge Version 3.0 Administration Guide
09-30000-0163-20061109

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fortibridge 3.0

Table of Contents

Save Article as PDF